Using Ethernet And Wifi Simultaneously
I am using a cat6 cord to run from my TV to my wireless netgear router for netflix to avoid the buffering. If I plug it in to the LAN terminal will my wife still be able to use the wifi with the laptop from that same router at the same time. So basically will the Wifi and the LAN terminal work simultaneously or can you only use one at a time. LAN connection and WIFI simultaneously TimCoult. Contributor - Level 2 07:40 AM. The safest way is to connect the X-Air to the WiFi router via an Ethernet cable and also connect your laptop to a second port on the router via it's own Ethernet cable. You then have both WiFi connection to the mixer as well as the hardwired laptop. Mar 29, 2018 Hi, I want to know why in my Win 10 Wi-Fi and Ethernet Connected at the Same Time?? If I plug-in my LAN, My Wi-Fi should disconnect If I use Wifi, My LAN should disconnect Any option to achieve this?? If i Check ipconfig/all it is displaying 2 IP's (one from wifi and another from LAN) Regards. Hi, About your WiFi and Ethernet issue, please refer.
I'm trying to connect my Raspberry Pi over ethernet to my closed local network router as well as connect to an Internet facing router using Wi-Fi. I followed this guide on stackexchange:
With two exceptions:
I didn't make my wlan0 configuration static
Can I Connect To Wifi And Ethernet
I left out the 'iface default inet dhcp' line at the bottom of /etc/network/interfaces because it resulted in no network connection whatsoever.
Where I'm at now:
I've got two IP addresses on the Pi, and both are valid. I've confirmed this by making connections to the closed network ip address and running 'iwconfig' and receiving positive results. Despite being valid IP addresses, the Pi does not seem to have a network connection. If I 'ping 8.8.8.8', I get the following:
PING 8.8.8.8 (8.8.8.8) 56(84) bytes of data.
From 192.168.1.1 icmp_seq=1 Destination Net Unreachable
From 192.168.1.1 icmp_seq=2 Destination Net Unreachable
From 192.168.1.1 icmp_seq=3 Destination Net Unreachable
The result of which is 100% packet loss. I've tried running 'ping -I <networkGateway> 8.8.8.8' but that seems to hang with no indication progress until I interrupt the command and see 100% packet loss still.
For completeness, heres my /etc/network/interfaces file:
It seems that the eth0 connection is taking priority over the wlan0 connection due to the 'From 192.168.1.1' at the start of the ping command, but I don't see where that might have been specified.
Any ideas?
Edit:
Worth noting this output on boot:
Edit2:
Ethernet Vs Wifi
Issuing 'ping -I wlan0 8.8.8.8' works! But loading a webpage in the browser doesn't.. Is there a way to set wlan0 as the default connection route?